|
|
Everywhere Fishermen are Raving About This Amazing New Wireless Remote Control Device!
 This is a typical Pro
Model installation
Step 1. The switch above is a typical two position switch that operates a hydraulic pump unit. The center wire is +12v. (power) The upper and Lower wires control the up and Down movement of the hydraulic pump unit.
 Step 2. The picture above shows the original wires removed from the switch and attached to the controller wires.
 Step 3. The
picture above shows the switch with the controller wires plugged back on to the switch with the original wires attached. We
are now ready to operate in either the manual mode, or the wireless mode. Now that you have attached the controller to the switch by using the diagram above, you are ready to connect the
controller to the power source.There are two wires with forked ends coming out of the
controller box. One is Black and one is Red. The Black lead is to be connected to the negative battery terminal. The Red lead
is to be connected to the +12v or positive side of the battery. Be sure to install a 20 amp in-line fuse in the positive lead
from the controller. IMPORTANT NOTE: You must use the same battery for the remote and the
power pole!! It ain't
Rocket Science Boys... It's That Simple! How Much Could This Possibly Cost?
|
Built by Fishheads for Fishheads